Baler Bollegraaf HBC 80 A, press power 78,5 tons, yoc 1997, only 21,545 operation hours, incl. chain belt conveyor Bollegraaf HBT 1200-1600

Technical data baler

Manufacturer Bollegraaf

Typ HBC 80 A

Year of construction 1997

Hours of operation 21,545 hours

Press power main press 78 tons

Press power of pre-press 42 tons

Feed channel 1,485 x 720 mm (l x w)

Filling volume 2,9 m³

Theoretic cycle time 22 sec.

Bale size 720 x 1,100 mm (h x w)

Drive power 45 kW

Connected load 60 kW

Tying system 5-fold, vertical, fully automatic

Throughput  capacity at a

bulk weight of 20 kg/cbm approx. 9,0 tons/hour

bulk weight of 50 kg/cbm  approx. 18,5 tons/hour

bulk weight of 100 kg/cbm  approx. 30,0 tons/hour

Throughput capacity with ruffler approx 20 tons/hour

Bale weight with a bale length of approx. 1.2 m approx 550 up to 800 kg

Filling volume hydraulic oil tank 750 l

Baler dimensions built up with hopper 10,700 x 2,150 x 6,783 mm (l x w xh)

Effektive transport dimensions only baler 10,700 x 2,150 x 3,000 mm (l x w x h)

Transport weight baler approx 24 tons

Accessories

Ruffler

Condition of the baler

Good condition, immediately ready for operation. The plant is still under power and can be inspected during operation without using any material.

Scope of delivery for the baler

Baler, ruffler, intermediate hopper for the infeed shaft of the conveyor belt, wire drawing stations (without wire), bale chute

Technical data for the conveyor belt

Manufacturer Bollegraaf

Typ HBT 1200/1600

Year of construction 2008

Drive power 5,5 kW

Effecting width 1,500 mm

Length of infeed conveyor 5,000 mm

Side wall height of infeed conveyor 500 mm

Length of ascending conveyor 12,100 mm

Pitch 30°

Side wall height of ascending conveyor 800 mm

Gooseneck length 1,400 mm

Slope gooseneck 15°.

Side panel height gooseneck 800 mm

belt speed 16 m/min.

Carrier made of angle steel, distance 900 mm, height 50 mm,

Scope of delivery for the conveyor belt

Conveyor belt with maintenance platform and ladder, pit cover, supports and feed hopper

Comments:

The entire press line (press with conveyor belt) will be sold ex works Netherlands as it is currently installed. Dismantling, splitting into freight units including loading is the responsibility of the buyer. This service can be offered separately on request.

The documentation (Manual, CE-declaration, electr./hydr.-drawings), are completely available.  Inspections are possible after agreement.  We will not assume liability for the given technical data and possible errors.