Baler Presto HPK 1100 K, press power 50 tons, yoc 2016, drive power 22 kW, only 2,21 working hours, like new, never been in use, ready for operation

Technical data baler

Manufacturer Presto

Typ HPK 1100 K

Year of construction 2016

Hours of operation 2,21 hours

Press power 50 tons

Specific pressing force 650 kN

Feed channel 1,250 x 1,050 mm (l x w)

Capacity per cycle time 0,96 m³

Theoretic cycle time 19 sec.

Theoretical idle power 181 m³/hour

Bale size 1,100 x 700 mm (w x h)

Driving motor 22 kW

Connetcted load 26,4 kW

Rated current 55 A

Tying system 4-fold vertical, fully automated

Throughput rate at a

bulk weight of 35 kg/cbm approx. 5,7 tons/hour

bulk weight of 50 kg/cbm  approx. 7,8 tons/hour

bulk weight of 100 kg/cbm  approx. 12,3 tons/hour

Bale weight up to 550 kg, depending on material

SPS controller (manuf., type) Siemens S7 1200

Touch panel Siemens GP4301TM

Transport dimensions only baler 7,200 x 1,800 x 2,500 mm (l x w x h)

Machine weight baler approx. 8,750 kg

 

Special equipment:

-        Special paint 80 um C-POX ST 180*1 in RAL 5005 for coastal atmosphere with moderate salt load.

-        Oil cooler

-        Intermediate hopper / feed shaft  with safety tear rope

-        2 wire roll boxes for 8 wire rolls 40 kg each

-        8 wire rolls 40 kg as machines first equipment

-        Bale slider to discharge the pressed bales

-        Menu language of the control system available in German and English

-        VPN -Router for online configuration of the program, update service and assistance with error messages online by the manufacturer. To use this service, the VPN router must be set up by the manufacturer and a SIM-M2M data card and/or a network connection of the customer (LAN or WLAN) is required.

 

Comments:

The press was purchased in 2016 especially for a project to press paper, cardboard and PE/PP films. During the project planning phase, the capacity requirements were drastically increased. Therefore, a larger press was installed and the existing machine was stored for the time. This press should be used for a second project, which was never realized. Therefore, the unused baler is now released for sale.

The machine is as good as new and have never been in production. The 2,21 operating hours result from the machine acceptance test with material input at the manufacturer.

 

The documentation (BA, CE, electrical/hydraulic circuit diagram), is completely available. An inspection is possible by appointment. We assume no liability for the technical data and possible errors.

 

Please note:

  • All technical data refer to specifications of producer/owner. We will not assume liability for the given statements and possible errors.
  • This offer is non-binding, prior sale excepted und revocable at any time.
  • Inspections possible after agreement. 
  • The sale is ex location, as it stands and lays, without liability and guarantee.