Baler unoTech, type 120 V5, 120 t cutting force, yoc 2009, drive power 2 x 75 kW, the baler was overhauled and tested

Technical data baler:

Manufacturer  unoTech GmbH, Niederlangen, Germany

Typ 120 V5

Year of construction 2009

Press force main press 100 tons

Specific press force 145 N/m²

Max. cutting force 120 tons

Press force free stamper 25 tons

Feed channel 2,000 x 1,020 mm (l x w)

Capacity per cycle time 1,5 m³

Theoretic throughput rate 650 m³/hour

Bale size 1,100 x 750 mm (w x h)

Driving motor 2 x 75 kW

Connected load 160 kW

Rated current 280 A

Tying system 5-fold vertical, fully automatic

Throughput rate at a

bulk weight of 20 to 30 kg/cbm up to 15 tons/hour

bulk weight of 35 to 50 kg/cbm  up to 23 tons/hour

bulk weight of 60 kg/cbm  up to 27 tons/hour

bulk weight of 100 kg/cbm  up to 44 tons/hour

Bale weight 600 up to 900 kg, depends on material

SPS controller (manuf., type) Siemens S7 300

Operating panel (manuf., type) Siemens SIMATIC

Transport dimensions only baler 13.630 x 2.350 x 3.130 mm (l x w x h)

Machine weight baler approx. 37 tons

Accessories 4 wire stations for a total of 10 pieces 500 kg wire coils (wire not included in the sales volume)

Condition of the baler:

The press was overhauled and intended for use in a newly built paper processing plant. However, this plant never went into operation. The machine has not been used since the overhaul and is therefore in very good condition and ready for immediate use.

Comments:

The documentation (Manual, CE, electr./hydr.-drawings), are completely available. An inspection during operation is possible by appointment. We will not assume liability for the given technical data and possible errors.